MWO-9-2300-378-34-2
TANK, COMBAT FULL-TRACKED
MODIFICATION WORK ORDER
JUNE 1984
MWO-9-2300-378-34-2 - Page 20 of 92
MWO 9-2300-378-34-2
(7) At rear of engine,
cut safety wire from two transmission Iifting eye bolts.
Remove and retain the two bolts (figure 7).
NOTE
During next step,
insure there is adequate clearance
between solenoid assembly and crankcase breather tube
(figure 7).
If solenoid assembly is going to contact
breather tube, the breather tube rubber hose may be
trimmed and tube pushed back into rubber hose to gain
sufficient clearance.
The solenoid bracket may also be
bent back slightly to gain clearance.
(8) Attach solenoid bracket to transmission lifting eye bracket with the two bolts
previously removed and torque bolts 50-60 lb-in. (5.6 -6.8 N.m) (figure 7).
(9) put safety wire on transmission lifting eye bolts (figure 7).
Figure 7. Installation of Solenoid Valve Assembly
18
Back to Top
