TM-9-2320-209-10-4
2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; OPERATOR LEVEL
SEPTEMBER 1980
TM-9-2320-209-10-4 - Page 26 of 87
TM 9-2320-209-10-4
Section
III. WHEELS EQUIPMENT ITEMS MAINTENANCE
2-5. JACKING PROCEDURE.
NOTE
This task is the same for all wheels. This task
is shown for the left rear-rear wheel.
TOOLS :
Hydraulic screw jack with handle
SUPPLIES :
Wood block
PERSONNEL: One
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set, wheels
choked.
FRAME 2
1.
Take hydraulic screw jack (1) and handle (2) out of stowage compartment above
left running board.
2.
Put wood block (3) on ground under axle housing (4) and put screw jack (1) on
wood block .
3.
Turn out screw jack (1) until it touches axle housing (4).
4.
Using slotted end of jack handle (2), turn bleeder valve (5) to the right. Put
jack handle in screw jack (1).
5.
Moving jack handle (2) up and down, raise wheel assembly (6) off ground.
END OF TASK
2-14
Back to Top
