TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 12 of 772
TM 9-2350-260-20-1-2
POWERPLANT REPLACEMENT (2A ENGINE) (Sheet 1 of 24)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
5-3
Installation
5-14
TOOLS:
5 ton hoist or comparable lifting device capable of lifting powerplant 12 ft. high
Ratchet with 1/2 in. drive
9/16 in. socket with 1/2 in. drive
7/16 in. socket with 1/2 in. drive
3/4 in. socket with 1/2 in. drive
Ratchet with 3/4 in. drive
1-1/2 in. socket with 3/4 in. drive
Torque wrench with 3/4 in. drive (0-600 lb-ft)(0-813 N
•
m)
7/16 in. combination box and open end wrench
Adjustable wrench (10 inch)
Spanner wrench
Flat-tip screwdriver
Putty knife
Pliers
Flashlight (if required)
Pinch bar (commander's station right side wall)
Hammer
Cutting pliers
SPECIAL TOOLS:
Powerplant lifting sling (Item 31, Chapter 3, Section I)
FABRICATED TOOLS:
Final drive guide shield (Fig. 1, Appendix F) (2 required)
SUPPLIES:
Adhesive(Item 2, Appendix D)
Covers for fire extinguisher tubing fittings
Covers for fuel return line fittings and press
Covers for primary fuel line fittings
Covers for air cleaner outlet hose connect points
Grease (Item 36, Appendix D)
Heavy masking tape (Item 57, Appendix D)
Rags (Item 65, Appendix D)
Dry cleaning solvent (Item 54, Appendix D)
Rubber gloves
Wooden block, 12 x 12 x 12 in. (3 required)
Lockwire (Item 60, Appendix D)
Lockwasher (MS35338-44) (4 required)
Lockwasher (MS35338-53) (2 required)
Lockwasher (MS35338-65) (12 required)
PERSONNEL:
Three
REFERENCE:
TM 9-2350-260-10
Go on to Sheet 2
TA147903
5-2
Back to Top
