TM-9-2990-206-34P
TURBOSUPERCHARGER AlRESEARCH MODEL T18C01
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
TM-9-2990-206-34P - Page 11 of 85
TM 9-2990-206-34&P
CHAPTER 1
INTRODUCTION
1-1. SCOPE.
Section 1. GENERAL INFORMATION
a.
Type of Manual. This technical
manual contains instructions for Direct
and General Support Maintenance of the
AiResearch Industrial Division Model
T18C01 turbosupercharger.
b.
Identification. The two con-
figurations of Model T18C01 turbosuper-
chargers covered by this manual are part
numbers 466392-1 (“clean air”) and
11669107-1 (standard). These two con-
figurations can be either right or left
hand mounted on various AVDS-1790 series
engines used in army vehicles.
c. Purpose of Equipment. Turbo-
superchargers are exhaust gas driven
centrifugal compressors.Their purposes
is to increase the amount of air deli-
vered to engine cylinders above that
available through unassisted air intake
1-2. MAINTENANCE FORMS, RECORDS,
AND REPORTS.
Department of the Army forms and records
used for equipment maintenance will be
those prescribed by TM 38-750, The Army
Maintenance Management System (TAMMS).
1-3. NOMENCLATURE CROSS-REFERENCE LIST.
This listing includes nomenclature cross-references used in this manual.
Common Name
Official Nomenclature
Backplate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Plate, Supercharger
Bolt . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . Bolt, Machine
Center Housing . . . . . . . . . . . . . . . . . . . . . . . .
.Housing Assembly, Center
Clamp . . . . . . .
.. . . . . . . . . . . . . . . . . . . . . . . . . . Coupling, Clamp, Grooved
Compressor Wheel . . . . . . . . . . . . . . . . . . . . . . . Impeller, Turbosupercharger
Compressor Wheel Nut . . . . . . . . . . . . . . . . . .
.Nut, Impeller
Heat Shield . . . . .
.. . . . . . . . . . . . . . . . . . . . . . Shield, Turbosupercharger
Insert . . . . . . . . . . . . . . . . . . . . . . . . . . . .
... . . Insert, Screw Thread
Lockwasher . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . Washer, Lock
Nut . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . Nut, Self-locking, Castellated, Hexagon
Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . Nut, Self-locking, Hexagon
Oil Drain Tube . . . . . . . . . . . . . . . . . . . . . . . . . Tube Assembly, Metal
"O" Ring
. . . . . . . . . . . . . . . . . . . . . . . . , . . . . . . Packing, Preformed
"O" Ring
. . . . . . . . . . . . . . . . . . . . .
. . .
. . . . .
.. Seal, Ring
Seal Ring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Seal, Ring, Metal
Shroud . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
.. Wheel, Shroud
Spacer Ring . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ring, Turbocharger
Stud . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stud, Plain
Thrust Ring . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ring, Thrust, Turbocharger
Thrust Washer . . . . . . . . . . . . . . . . . . . . . . . . . . Washer, Bearing, Thrust
Turbine Wheel . . . . . . . . . . . . . . . . . . . . . . . . . . Turbine Wheel Assembly
Change
1
1-1
Back to Top
