PS Magazine - FEBRUARY 1974
PS, The Preventative Maintenance Monthly
ISSUE 255
FEBRUARY 1974
This's probably because the last man
who assembled the gUn removed the rotor
from the gUn hoUsing the harD way-by
hammering on the end of the rotor. This
±istorte² the %³in hole at the rear of the
ROUGH
·
HANDLING
BUTChES
,7/a-IN HOLe
rotor. When he put I´ all together he had
to force the support to ·seatµ No wOnder
it stUck!
Free a ¶rozen GUn sUpport this way:
¸nsert a punch or drift¹brass is beStº
through the center hole in front of the
Rotor. This is the ba»rel end¹minus the
About
812
inches inside the rotor, the
drift or punch will contact the inner lip
of the aft sUpport. Light tapping on the
punch with a hammEr should ¼»ee the sup½
port without damage¾
26
When ready to as-
semble tHe minigun,
eyebaL± the rear of
t²e rotor.
IF neces-
sary,
d»ess it
w³t² a
HAlF´round Mediuµ
cu¿ Àle ¿o remoVe any
bu»rs.
Back to TopBack to Top
