T
hold the aligning pIns To The
Dev±ce, we useD mach±ne
screws,
NSN
5305-00-043²2680.
³he ³M says To weLD The aLLgnLng
p±ns, buT we founD ´T eas±er To
Tap anD boLT on The p±ns.
³h±s acTs as a
GO/NO-GO
gauge for The aLLoweD 0µ06-Ln
ToLerance¶
I
e±Ther porT±on of The
p±n f±Ts ´nTo The swashpLaTe hoR
hoLe, The r±gg±ng ·s gooDµ ´f
ne±Ther porT±on of The p±n goes
±n, more aDjusTmenT ´s neeDeDµ
l
S±nce your measur±ng Dev±ce
no Longer s±Ts on The Trans¸
m±ss±on case, you neeD To make
a supporT ThaT mounTs To The
boTTom s±De of The Transm±ss±on
Top caseµ
We useD seven ·nches of
3/s
x
1-±n ±ron sTock¹
NSN
9510-00-
5º-4922µ
»r/·· a
3/s
-·n hoLe ´n one enD
as cLose as poss±bLe anD rounD
oF The co¼ers so The supporT
w/½½ boLT up To The unDer s±De of
The Transm±ss±on anD noT
´nTerfere w±Th The Transm±ss±on
caseµ
1
SG
AnDy Bo¾´nger
CoLumbus,
OH
We aLso TuReD The ouTs±De
D±mens±ons of The aLLgnLng p±ns
Down 0.120 ´nch, raTher Than The
¿µ50 ´nch of The or±g±naL p±ns.
-±²³´µ¶
First
SeRge
anT
BolIn
geR
'
±de
has
been
blessed by A²CO
M and H³s
work a´d
works. As
aLways, a
good
jµb¶
Andy·
t
±8