PS Magazine - TB 43-PS-584
PS, The Preventative Maintenance Monthly
ISSUE 584
JULY 2001
PS 584
Pins and Knobs
Painting
If selector
positions
are painted
over, stencil
them on
Feel the locking knobs on the rails for looseness. If the knobs become too loose,
they come off and so does the rocket. Tighten loose knobs with a wrench.
During setup, make
sure the locking pin for
the landing leg is fully
inserted. If the pin is
missing or it works out,
the leg can collapse.
Tighten
loose knob
Make sure
locking pin
is fully
inserted
Test the strength of the
launcher locking pins by
gently pulling on them. If a
pin's spring is worn out, the
locking pin will come out. A
weak pin lets the launching
arm fly out of position during
firing. That's dangerous.
Hope we
cleared up
your mine-
clearing
problems!
27
Locking pins
should hold
REMOTE
RAISE
MANUAL
RAISE/LOWER
PRESSURIZE
ACCUMULATOR
Before the MICLIC goes to the
paint shop, cover the markings for
the hydraulic control selector
valve. If the markings are painted
over, you'll be guessing what
you're selecting. The settings are
already painted over? Have your
repairman stencil them on. See Fig
1.29 in the TM for the settings.
584. 24-27 2 (C)
6/4/01
8:15 PM
Page 3
Back to TopBack to Top
