PS Magazine - TB 43-PS-634
PS, The Preventative Maintenance Monthly
ISSUE 634
SEPTEMBER 2005
PS 634
SEP 05
23
SECM…
Dear Half-Mast,
We have lost the
foam inserts that go in
the drawers for the
SECM (shop equipment,
contact maintenance).
Without the inserts, it
is much harder to keep
the tools organized and
do inventory. We’ve
looked through TM 9-
4940-563-13&P and
can’t find any NSNs
for replacements.
Can you help?
MSG K.V.
Dear MSG K.V.,
Sure. There are no NSNs for replacement foam
inserts, but replacements can be fabricated by the
vendor. To do that, you will need to go through
TACOM-Rock Island.
They
will
need to know your SECM’s NSN and serial num-
ber, which can be found on the data plate on the
rear of the shelter, and which drawers need
replacement inserts.
Contact
TACOM-RI
at DSN 793-4674/(309)
782-
4674
PS 634
SEP 05
22
Small
Emplacement
Excavator…
o
perators, make sure you pay attention to
the CAUTION in Note 18 of the LO when
it’s time to lube the grease fittings for the
front and rear thrust ball joints on the SEE.
Give each fitting only four or five pumps
of lube from a hand-held grease gun.
Pumping in too much lube will split open
the ball joint’s rubber boot. A split boot
means the lube leaks out and water and sand
get in. Water can rust the ball joints and sand
just causes more wear and tear.
Dear Sergeant R.L.,
Check out TM 9-4940-563-13&P. You can order a copy
through your pubs account or look at it on-line:
You will need a password to access the TM. The contact
maintenance truck’s component list is CL 4940-95-B29
and is at:
army.mil/sko/index.cfm
we lost
your drawer
inserts
during the
trip to iraq.
what’s the
matter?
and I
can’t
figure out
how to get
replace-
ments!
shoot, we can
probably get
some
made.
let’s
contact
tacom.
easy on lube
…but I don’t
know
where
your tm is.
Dear Half-Mast,
Where do you
go for info on the
contact shop
truck? We can’t
find anything on
maintenance or
NSNs for the
shop equipment.
SGT R.L.
Lube front and
rear thrust ball
joints with 4-5
pumps only
Contact Maintenance Truck…
get a copy
of tm 9-
4940-563-
13&P. it has
all the info
you need!
How Can I Get Drawer Inserts?
I know there’s some
PMCS I’m s’posed to
be doing for you…
now it’s gonna
be
tough
trying to keep
track of all
your tools.
634.22-23(C).qxd
7/25/05
5:32 PM
Page 1
Click here for a copy of these articles to save or email
Click here for a copy of this article to save or email
Back to TopBack to Top
