PS Magazine - TB 43-PS-691
PS, The Preventative Maintenance Monthly
ISSUE 691
JUNE 2010
60
PS 691
JUN 10
Connie's
Post Scripts
M4K RTFL Engine Warranty
Your rough-terrain forklift’s engine re-power
kit, NSN 2815-01-529-2006, comes with a
one-year warranty. The warranty covers the
engine when it’s installed on the forklift—
not when you receive the kit. Warranty
paperwork comes with the kit, so Fll it out
ASAP after installation. If you lose a copy of
the warranty, request a new one from:
Make sure you include the engine’s serial
number and date when it was installed.
CNH America LLC
Attn: Defense Products Group (M4K)
621 State Street
Racine, WI 53402
Electronic Gun Card Revisited
The electronic gun card article on
Pages 2-5 of PS 688 (Mar 10) needs two
clariFcations. ±irst, Step 1 on Page 4
says to notify Team Armor whenever
you transfer, turn in, store or send your
equipment for rebuild or overhaul. That
applies
only
to M1-series tanks. ±or
other equipment, notify the appropriate
POC listed at the bottom of Page 5.
Second, the DSN for the mortar POC on
Page 5 has an extra digit. The correct
DSN is 786-8783.
Return CBPS Overpack Boxes
If you get the chemical biological
protective system (CBPS) basic issue
items (BII) back from Reset, don’t throw
away the overpack boxes they come in.
The boxes are expensive and are needed
by Pine Bluff Arsenal to send out more
CBPS BII. Instructions on sending the box
back to Pine Bluff are stamped on its
outside. If you have questions about the
overpack boxes, email:
mark.oldham1
@us.army.mil
or call DSN
793-1506,
(309)
782-1506,
or email:
bryan.janoski
@us.army.mil
HMMWV Traversing Gear Assembly
HMMWV GPK traversing gear assembly, NSN 5340-01-536-2054, has been replaced by
an upgraded assembly, NSN 1005-01-563-4655. This upgrade should reduce the failures
associated with the original assembly.
The new traversing gear assembly is a direct replacement for the original assembly, but
the crank handles are different. The upgraded crank handle, NSN 5340-01-563-6839, Fts
into the gear shaft and is held in place with a quick-release pin. The original crank handle,
NSN 5340-01-536-0999, Fts over the gear shaft and is held in place with set screws.
HMMWV Spring and Shock NSNs
Here are the spring and shock NSNs for M1151,
M1151A1 (with B1 kit), M1152, M1152A1 (with
B2 kit), M1165, M1165A1 (with B3 kit) and
M1167 up-armored HMMWV suspensions:
²³²
´µE¶
Front helical spring
Rear helical spring
Front shock service kit
(shocks included)
Rear shock service kit
(shocks included)
TS-4530 Radar Test Set Upgrade
The TS-4530/UPM radar test set (NSN 6625-01-483-1794, LIN T99847, PN 50-1045-70)
for identiFcation friend or foe (I±±) testing will soon require an upgrade for Mode S
(·nhanced) and Mode 5 Crypto. The upgrade will be performed by the Feld maintenance
calibration support facility (military or civilian) nearest to your location.
To receive the upgrade kit, send DA ±orm 5106,
Mission Support Plan,
with your POC,
location, unit identiFcation codes, nearest repair/calibration facility, and the number of
test sets authorized and on-hand to the PD TMD· T·MOD Product OfFce.
Call DSN 788-0146, (256) 842-0146, or email:
benita.cross
@us.army.mil
or DSN 897-2923, (256) 313-2923, or email:
paul.aymond
@us.army.mil
When the TS-4530A/UPM is upgraded, its NSN will change to 6625-01-562-0715 and its
part number to 90000125. Its LIN will remain the same.
M1A1 Hub Cap Replacement
Use NSN 2530-01-552-1192 to order a new hub cap for the hub and arm assembly on your
M1A1 tank. NSN 2530-01-063-5862, which is shown as Item 14 in ±ig 246 of TM 9-2350-264-
24P-1 (Mar 03 w/Ch 6, Jun 09), is a terminal item.
Free Blowgun Kit
The Frst standard automotive tool sets (SATS), NSN
4910-01-490-6453, sent to the Feld did not include the
Blowgun kit used for cleaning air Flters. If your SATS has
a serial number from KTC-SATS 0001 through KTC-SATS
1119, you can get a free Blowgun kit.
±or requisition info, go to the PM-SKOT website:
.
Click on Check your
System SKO on Wrty/Rplcmnet web page for RetroFt
Availability. Then click on RetroFt and Fll out the form.
Questions? Call TACOM-Rock Island at DSN 793-
3385, (309) 782-3385, or email:
robert.drinkall
@us.army.mil
M1064A3 Ramp
Actuator Fitting
NSN
Get a new pipe nipple for
the ramp actuator on your
M1064A3 mortar carrier using
NSN
(PN
A733XS-25C±B, CAGE 81346).
NSN 4730-01-070-0582, which
is shown as Item 6 in ±ig 329
of TM 9-2350-277-24P (Oct 03,
w/Ch 4, Oct 09), is too large.
691.60-61.indd
1-2
5/3/10
2:20:05 PM
Click here for a copy of these articles to save or email.
Back to TopBack to Top
