PS Magazine - TB 43-PS-692

PS, The Preventative Maintenance Monthly

ISSUE 692

JULY 2010
PS Magazine - TB 43-PS-692 - Page 30 of 33
57
PS 692
JUL 10
Versions 2.1.1. and older are compatible with Windows 2000, Windows XP,
CentOS 4.6 and RedHat Enterprise 4.6.
Versions 2.1.2 and newer will work with Windows 2000, Windows XP, Windows
Vista, CentOS 5.3 and RedHat Enterprise 5.3.
Note:
Windows 7 OS is not currently supported.
EMS-NG Viewer Versions 2.1.1 and older can run on Windows Vista; however,
after your administrator installs the EMS-NG Viewer on your PC, you will need to
put Disk 3 (the IETM content) in your CD-ROM or DVD drive every
time you want to access the TM data.
•
MS Windows 2000 Professional SP4
(512 MB RAM minimum)
•
MS Windows XP Professional
(512 MB RAM minimum)
•
MS Windows Vista Enterprise
(1 GB RAM minimum)
•
RedHat Linux 5.3
(512 MB RAM minimum)
•
CentOS Linux 5.3
(512 MB RAM minimum)
•
600 MHz processor or greater
•
1024 x 768 x 16-bit screen resolution
•
20 GB hard drive
•
CD-ROM or DVD-ROM drive
If installation does not begin
automatically after you insert the
disk into a CD-ROM or DVD drive,
choose Start in the Windows taskbar,
then click Run. In the box that opens,
type the following: [drive]:\setup.
exe (but replace the word drive with
the letter of your CD-ROM or DVD
drive). Click OK or press Enter and
follow the installation instructions on
the screen.
You must also install the Auto-
nomous Diagnostic Manager (ADM)
software to perform diagnostic tests
on a vehicle. The ADM software is
usually distributed with the viewer
and is the second disk in the folder.
If you need paper copies of an
operator’s manual and/or hand
receipt, do the following:
From the opening screen, select
a vehicle model.
Once inside the program, select
Help from the menu selection at
the top of the IETM.
Choose About This TM,
and then click Paper Copies of
Operator’s Manual from the
Table of Contents on the left.The
hand receipt is a pdf link on this
page and can also be accessed in
the General Information Work
Package under the Introduction
section.
For EMS-NG support, contact the publication manager for your vehicle. The EMS
team at TACOM also has an AKO page with more information. Visit the website:
For follow-up EMS-NG support, call the manufacturer, O’Neil, at
1-800-413-6723 or email:
EMSsupport@oneil.com
supported operating
systems and minimum system
requirements for the ems-ng
viewer are…
ONE THinG I predict is…
EMS-NG and the older EMS-2 can
both be installed and run on the
same PC, laptop or maintenance
support device without conflict.
are you an
administrator?
read this!
if you’re
a
user,
you need
to read
this!
692.56-57.indd
1-2
6/2/10
1:23:01 PM
Back to Top
Back to Top