PS Magazine - TB 43-PS-708

PS, The Preventative Maintenance Monthly

ISSUE 708

NOVEMBER 2011
PS Magazine - TB 43-PS-708 - Page 11 of 33
18
PS 708
NOV 11
19
PS 708
NOV 11
T
he gunner’s
sliding hatch inner
lock assembly latch
pin on the MRAP
MaxxProPlus is
falling out of place
because of a faulty
C-clip. That means
the hatch can slam
down without
warning on the
gunner! Refer to
WP 4-14.4 of TM
9-2355-318-23-3
on how to remove
the C-clip, Item 9,
and the latch pin,
Item 10, and how
to replace them
with retroFt latch
and cotter pins. See
TACOM GPA 09-
020 for more info:
•
engine oil filter
•
transmission filter (s)
•
primary air filter
•
fuel/water separator
element
•
fuel filter
•
air-dryer filter
•
and other vehicle specific
service parts
MRAP Vehicles
NSN
RG-33/RG-33 Plus
RG-31A2/A2M1/A2RTR
RG-31A3
Cougar
MaxxPro
MaxxPro Plus (Ambulance
and Dash Service Kit)
Caiman/Caiman Plus
MRAP Gunner’s
HatCh LatCh Pin
MRAP Vehicles…
New Service Kits
by the way, you
will
need your
cac to access
this website.
mechanics, need to
pull annual maintenance
on your mrap vehicles?
use this handy list for
the service kits you need
to perform those required
checks and services for
the following vehicles…
by the way, each of these service
kits contains the following items…
Locate gunner hatch latch retention pin
Use
pliers to
remove
current
C-clip
that is
holding
latch
pin in
Install new clevis and cotter pin; bend cotter pin as shown
708 18-19.indd
1-2
10/4/11
10:41 AM
Click here for a copy of this article to save or email.
Click here for a copy of this article to save or email.
Back to Top
Back to Top