PS Magazine - TB 43-PS-712

PS, The Preventative Maintenance Monthly

ISSUE 712

MARCH 2012

PS Magazine - TB 43-PS-712 - Page 12 of 32
20
PS 712
MAR 12
21
PS 712
MAR 12
Sure, you can slow the damage by occasionally wiping away any condensation
in the ammo compartment. But to really put the brakes to corrosion, you’ve got to
stop moisture.
A few bags of desiccant will do
the trick. Just open each ammo
door and put a bag or two on the
Foor between the ammo tubes and
the compartment wall. NSN 6850-
00-264-6571 gets a drum of 300
bags of desiccant.
When it’s time to pull PMCS on
the hull ammo compartment, check
the desiccant bags. If they’re moist
to the touch or if the compartment
walls are wet again, it’s time for
new desiccant.
Coat
assembly
with GAA
to protect
against
battery
acid
M
echanics, a little battery acid in the wrong place will damage more than the
batteries. You have to worry about what’s
under
the batteries, too.
In the case of your M88A1 recovery vehicle, that’s the steering linkage bell crank
assembly.
The assembly is to the side and below the battery box, so any battery leakage
usually ends up on it, too. If it’s not lubed regularly, the resulting corrosion makes
the rods brittle. Eventually, they break.
So, before you lube the steering linkage bell crank assembly quarterly with GAA,
carefully wipe off any corrosion you ±nd with a rag. If the corrosion is heavy, use a
solution of water and baking soda. Wear rubber gloves and safety glasses to protect
your hands and eyes.
Next, put a light coat of GAA on the
outside of the assembly, then use your
grease gun to lube normally. The GAA
helps protect the assembly from battery
corrosion until it’s time to lube again.
M1-Series Tanks…
soak up the humidity
M88A1 Recovery Vehicle…
A Little Lube’ll Do it
humidity in the ammo compart-
ment will rust and corrode
onboard ammo, whether your
tank stays uploaded all the
time or only during exercises.
man, it’s
humid!
I’m
soaked!
you think
you’re
wet? you oughta
see my ammo
compartment!
nuts!
corrosion can’t
catch a break
around here!
that’s ‘cause my
mechanic knows how
to use his lube!
and check the
battery box and
its contents
for corrosion
problems, too.
Place desiccant on floor of ammo compartment
712 20-21.indd
1-2
1/23/12
4:47 PM
Click here for a copy of this article to save or email.
Click here for a copy of this article to save or email.


Back to Top
Back to Top