DMWR-9-2815-220
AVDS-1790 ENGINE OVERHAUL STANDARD
DEPOT MAINTENANCE WORK REQUIREMENT
DMWR-9-2815-220 - Page 493 of 1422
)
±
DMWR 9-2815±220
5-60.1±
Reclamation.
Use the procedu±es outlIned below to recLaIm a WorN accesso²y
d³ive housIng (pa³t no´
²²642²21-²).
Refe³ to
OIP
1³642121-² (5/366)´
aµ
RePair Wor¶ mati¶g s·rfaces of the meCHanIcal d³ive HousIng and rear fan
Hous¸ng by INsta¹ling sHimsµ
(²)
ReMove studs a¶d MIº» Worn a³eas to a deptH oF
0´050
InC¼esµ
.·
(2)
½nstal¾
0´060
inCh tHick aluMinum shims cut to the sHaPe of t¿ mIlled
areas.
(3)
To ³etai¶ sÀIms, D³i»¾ Ào¾es
0±²59
InCÀ diaMete³ and
0´100
InÁ¼ deeP,
through shIms.
(4)
Tap d³Iººed hoÂes
²0-32 NF2 0.094
I¶CÀ deeP´
(5)
Ão Positio¶ and retain tÀe shIms, use
3/16
InCH diameter alumiÄum Bar
stocK, cut to t¿e requI³ed Åe¶gtÀs and th²eaded
µ0-32 NF2´
SCreW threaded alumI-
num stock
Æn taPped Àoºes.
(6)
ÇNsta¾»
3/8
InCh diamete³ ove³size studsÈ
Éhe¶ fastenINg bearing
supports WIt¿
3/8
inCh nuts,
use lubrIPlate and torQue to
275 - 325
PouNd InChesµ
b´
RePaIr a Wor¶ i¶jeCtIon adva¶Ce bore oF tÀe meCÀa¶ical d³ive HousinG by
Instaºling an iNse³t type beari¶g.
Refe³ to fIg·re
5¶59´l (5/35·.2).
(²)
Éith caP in pºace, ÊaCHINe the INJection advanCe bore to
2´5²0
incHes
¸´0´
(²)
Ëith caP removed, MaChINe slots In bea³Ing areas
5¹59´2 (5/354´2)´
as shoWN ÌN fIgure
,flL
(3)
UPon assembºy of tÀe aCCesso³y d³ive Àousi¶g, instaºº
1
Í\Îg
(part no.
º
²
4
}
»u
³
In tÀe inJectIoN advance bore.
-
v
'´µ(
N
S
/
3/.c-oJ,19±
¼Zh<½
5/35¾¿l
a
¶
sutT
·
Back to Top
