LO-9-2320-209-12-1
TRUCK, CHASSIS: 2 1/2 TON, 6X6, M44 SERIES
LUBRICATION ORDER
APRIL 1983
LO-9-2320-209-12-1 - Page 2 of 36
OIL CAN POINTS
DO NOT LUBRICATE
Every 1,000
miles (1,600 km) or monthly,
Springs, leaves,
clutch release bearing,
lubricate: door, tailgate, windshield and side
generator, alternator, starter, and shock
panel hinges, locks and latches, transfer case
absorbers.
and power takeoff shift linkage, clutch and
brake pedal linkage, handbrake shoe outer
LUBRICATE
AT TIME OF ASSEMBLY BY
pin, handbrake control, winch propeller shaft
DIRECT SUPPORT (DS) AND GENERAL
shear pin, rear winch and power-divider
SUPPORT (GS) PERSONNEL
control lever linkages, earth boring machine
operating handle linkage, outrigger control
Clutch pilot bearing, clutch release bearing
lever linkage, discharge valve control lever
carrier, speedometer flexible shaft, revolving
pivot pin, and tailgate control lever linkage
platform bearings, and lineguide roller shaft
with seasonal grade OE. Coat roller sheave
bearings.
spindle bars with thin layer of GAA. For
vehicles in storage,
oil and operate the
GENERAL NOTES
handbrake lever at 30-day intervals to allow
for penetration of lubricant between the
General notes are located on pages 30
handbrake lever shaft and housing.
through 33.
NOTE
All Iubrication capacities are approximate (approx).
Military symbols for lubricants are found in general notes number 21.
Hours in the interval column refer to hours of operation. When two intervals are shown, lubricate at the interval
which occurs first.
LO 9-2320-209-12-1
PAGE 2 OF 34
Back to Top
