LO-9-2350-256-12
RECOVERY VEHICLE, FULL TRACKED MEDIUM, M88A1
LUBRICATION ORDER
NOVEMBER 1995
LO-9-2350-256-12 - Page 2 of 41
LUBRICATION
LO 9-2350-256-12
ORDER
28 February 1986
(Supersedes LO 9-2350-256-12 July 1976)
RECOVERY VEHICLE, FULL-TRACKED
MEDIUM, M88A1
Intervals (on-condition or hard lime) and the related man-hour
NOTE
times are based on normal operation. The man-hour time speci-
fied is the time you need to do all the services prescribed for a
Always install dust caps on fittings
particular interval. On-condition (OC) oil sample intervals shall
after lubrication procedures.
be applied unless changed by the Army Oil Analysis Program
(AOAP) laboratory. Change the hard-time if your lubricants are
contaminated or if you are operating the equipment under
Clean parts with dry-cleaning solvent, type II (SD-2) or equiva-
adverse operating conditions, including longer-than-usual oper-
Ient. Dotted arrow points indicate lubrication on both sides of
sting hours. The hard-time interval may be extended during
the equipment. The lowest level of maintenance authorized to
periods of low activity. If extended, adequate preservation pre-
Iubricate a point is indicated by one of the following symbols as
cautions must be taken. Hard-time intervals will be applied in
appropriate: Operator/Crew (C); and Organizational Mainte-
the event AOAP laboratory support is not available.
nance (O).
Reporting errors and recommending Improvements. You can
WARNING
help improve this manual. If you find any mistakes or if you
know of a way to improve the procedures, please let us know.
Dry-cleaning solvent, type II used to
Mail your letter or DA Form 2028 (recommended Changes to
clean parts, is potentially dangerous
Publications and Blank Forms) directly to: Commander, U.S.
to personnel and property. Do not
Army Tank-automotive and Armaments Command, ATTN:
use near open flame or excessive
AMSTA-IM-MMAA, Warren, MI 48397-5000. A reply will be fur-
heat. Flash point of solvent is 138°F
nished to you.
(58.8°C).
TOTAL MAN-HOURS
INTERVALS
MAN-HOURS
D
7.3
M
11.3
S
9.0
A
1.0
OC
5.8
After fording
24.0
*If AOAP support is not available and hard-time
Intervals are used, 2 man-hours will be required for
each 25-hour period or monthly (whichever comes
first); additionally, semiannual labor requirements
wiII Increase by 2.5 man-hours.
LO 9-2350-256-12
Change 1
CARD 1 of 38
Back to Top
