MWO-9-2320-260-30-1
TRUCK TRACTOR WRECKER 5-TON MODEL M819 (NSN 2320-00-050-9004)
MODIFICATION WORK ORDER; INSTRUCTIONS FOR MODIFICATION OF FRONT WHEEL HUBS AND FRONT TIRE RIMS FOR USE WITH 12:00 X20, 16 PLY TIRES
AUGUST 1982
MWO-9-2320-260-30-1 - Page 7 of 12
m.
Install warning decal P/N 12300572 next to new instruction and data plate.
n. Change tire pressure markings on both left and right side fenders to read
TP-105, in accordance with TB-43-0209.
11.
CALIBRATION REQUIREMENTS.
Not applicable
12.
WEIGHT AND BALANCE DATA.
Weight and balance are not significantly affected.
13. QUALITY ASSURANCE REQUIREMENTS.
Not applicable.
14.
RECORDING AND REPORTING THE MODIFICATION.
a. Records and Reports Forms.
(1) DA Form 2408-5 or DA Form 2409.
Record the modification on DA Form
2408-5, Equipment Modification Record, when multiple form assembled
Equipment Logbook is applicable,
or DA Form 2409, Equipment Maintenance
Log (Consolidated).
(2) Completion of DA Form 2407, Maintenance Request. The serial number to be
reported in Block 2 must be in the serial range stated in paragraph 3 of
the MWO.
The NSN for components, assemblies, and subassemblies to be
reported in Block 6 must be the same as the NSN shown in paragraphs 4 and
5.
The NSN of the item actually modified will be entered in Block 20h.
This NSN must match the NSN shown in Block 6. The UIC to be reported in
Block 1
C
must be the six character code that is put on the Unit/
Organization shown in Block la.
(Normally, this will be the code that is
put on the Unit/Organization Morning Report.) List by NSN the number of
kits used to accomplish this MWO using Block 20 and/or Block 35. If more
space is needed , use DA 2407-1, Continuation Sheet. After completing the
form, mail the NMP copy (Copy 2) to:
Commander, US Army Tank-Automotive
Command ATTN:
DRSTA-MRP, Warren, MI 48090. Mail the control Copy (Copy
3) to :
Commander, US Army Depot System Command, ATTN: DRSDS-PM,
Chambersburg, PA 17201, for PAC 98 (Non-AIF Field Activities). Forward
the Organizational Copy (Copy 4) as directed by local commander. See
Appendix C for examples of DA Form 2407.
(3) DA Form 2408-9. Not applicable.
b .
Marking Equipment.
(1) Mark the equipment by stamping
“MWO 9-2320-260-30-1” in a conspicuous
location near the identification plate of the end item modified .
(2) A new data plate is furnished as part of the modification kit. The new
data plate replaces the old data plate.
(3) A warning decal is furnished as part of the modification kit. This deca l
is installed on inside of left cab door .
6
Back to Top
