MWO-9-2320-279-20-8
MODIFICATION OF M983 HEAVY EXPANDED MOBILITY TACTICAL TRUCK (HEMTT) TRACTOR
MODIFICATION WORK ORDER; INSTALLATION INSTRUCTIONS FOR NATO SLAVE CABLE RETENTION DEVICE
NOVEMBER 1992
CHANGE 1
MWO-9-2320-279-20-8 - Page 8 of 14
MWO 9-2320-279-20-8
c. Install six slave cable support hooks.
NOTE
It may be necessary to remove expanded metal
(grid) when drilling holes.
(1)
Drill two .34 inch diameter holes (1) and
(2) as indicated.
NOTE
All hooks will be assembled and installed
basically the same way.
The position of the
hooks may vary.
TYPICAL HOOK AND
MOUNTING HARDWARE
(2)
Install nut (8) and flat washer (9) on hook
(7).
Insert hook (7) in drilled hole (1) and
secure with flat washer (9), lockwasher
(10) and nut (8).
The loop of the hook (7)
should be facing to the side and rear of the
vehicle (approximately 450 angle) to allow
installation and removal of the slave cable.
(3)
Insert hook (7) through underside of drilled
hole (2).
Make sure loop of hook is facing
inward.
NOTE
If hooks are too large for existing holes in tool
stowage box, ream out holes to .34 inch
diameter.
(4)
Install nut (8) and flat washer (9) on two
hooks (7).
Insert hooks (7) in existing
holes (3) and (4) located in bottom of tool
stowage box.
Secure hooks (7) with flat
washer (9), lockwasher (10) and nut (8).
The loop of the hooks (7) should be facing
inward.
(5)
Drill two .34 inch diameter holes (5) and
(6) as indicated.
(6)
Install nut (8) and flat washer (9) on two
hooks (7).
Insert hooks (7) in drilled holes
(5) and (6) and secure with flat washer (9),
lockwasher (10) and nut (8).
The loop of
the hooks (7) should be facing up.
6
Back to Top
