MWO-9-2320-280-35-2
MODIFICATION WORK ORDER
MODIFICATION OF THE HIGH-MOBILITY MULTIPURPOSE WHEELED VEHICLE; M998 SERIES; 3-POINT SEATBELT RESTRAINT SYSTEM FOR BASIC ARMORED AND NON-ARMORED VEHICLES
OCTOBER 2005
CHANGE 2
MWO-9-2320-280-35-2 - Page 14 of 116
MWO 9-2320-280-35-2
9
NSN
NOMENCLATURE
CAGEC
PART NO.
QTY.
Template
19207
12342729
1
Template
19207
12342730
1
Template
19207
12342732
1
Template
19207
12342733
1
Template
19207
12342737
1
Template
19207
12342738
1
Template
19207
12342739
1
Template
19207
12342740
1
10.
MODIFICATION PROCEDURES.
10.1.
FRONT SEAT, NON-ARMORED VEHICLE.
WARNING
All seatbelt anchor point hardware must be replaced with the new
hardware provided in the kit to ensure adequate strength. Failure to
do this may result in injury to personnel.
NOTE
Body side panels beneath the "B" pillar must be free of dents and/or
body filler material to ensure structural rigidity when reinforcements
are installed. Body side panels damaged or previously repaired must
be replaced prior to installation of this kit.
a. VEHICLE PREPARATION.
(1) Disconnect battery ground cable. (Refer to TM 9-2320-280-20.)
(2) Remove fixed doors, if installed. (Refer to TM 9-2320-280-20.)
(3) Remove cargo barrier, if installed. (Refer to TM 9-2320-280-20.)
(4) Remove rear curtain, if installed. (Refer to TM 9-2320-280-20.)
(5) Remove rear seat backs, if installed in stowed position. (Refer to TM 9-2320-280-20.)
(6) Remove enclosure panels. (Refer to TM 9-2320-280-20.)
(7) Remove driver's seat and seat back cushions. (Refer to TM 9-2320-280-20.)
(8) Remove driver's seat frame. (Refer to TM 9-2320-280-20.)
(9) Remove shelter, if installed. (Refer to TM 9-2320-280-20.)
(10) Remove troop seats, if installed. (Refer to TM 9-2320-280-20.)
(11) Remove companion seat back. (Refer to TM 9-2320-280-20.)
(12) Remove front seatbelt assemblies. (Refer to TM 9-2320-280-20.)
b. LEFT RABBET REINFORCEMENT INSTALLATION.
NOTE
It may be necessary to replace identification data plate if damaged
during removal.
(1) Mark an outline around identification data plate and driver's seat adjustment decal on left rabbet
assembly as shown in figure 1.
Back to Top
