SMI-9-2320-387-14P-1
TRUCK, UTILITY: EXPANDED CAPACITY
SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS
JULY 2004
SMI-9-2320-387-14P-1 - Page 459 of 671
SMI 9-2320-387-14&P-1
Change 4
D-93
1.
Using existing turret handle (1) as a template, scribe two reference lines (2) on weapon station (4).
2.
Locate and mark the center of six spot welds (3) on turret handle (1).
NOTE
Ensure drill does not penetrate weapon station.
3.
Using 0.313-inch diameter drill bit, drill out six spot welds (3) in turret handle (1).
4.
Using chisel, remove turret handle (1) from weapon station (4).
NOTE
When grinding weapon station, ensure that the two reference
lines are not removed.
5.
Grind off any remaining spot weld (3) material flush with weapon station (4).
6.
Using two reference lines (2) marked in step 1, position turret handle (5) on weapon station (4).
7.
Using turret handle (5) as a template, drill four 0.344-inch diameter holes (6) in weapon station (4).
8.
Spot paint weapon station (4) (refer to TM 43-0139).
9.
Install turret handle (5) on weapon station (4) with four washers (8), capscrews (7), washers (8), and
locknuts (9).
10.
Spot paint capscrews (7) and locknuts (9) (refer to TM 43-0139).
INSTRUCTIONS:
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
MATERIAL BLOCK
STOCK SIZE
DESCRIPTION
NSN
N/A
LOCKNUT
N/A
WASHER
N/A
BOLT
N/A
HANDLE
P/N
12446730
Back to Top
