SMI-9-2320-387-14P-1
TRUCK, UTILITY: EXPANDED CAPACITY
SUPPLEMENTAL OPERATION, MAINTENANCE, AND REPAIR PARTS INSTRUCTIONS
JULY 2004
SMI-9-2320-387-14P-1 - Page 82 of 671
SMI 9-2320-387-14&P-1
7-34
Change 4
7-11. BRAKE PROTECTION GUARDS REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
All
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Six locknuts (without 10,500 lb hydraulic
winch) (Appendix G, Item 106)
Three locknuts (with 10,500 lb hydraulic
winch) (Appendix G, Item 106)
Six locknuts (Appendix G, Item 82)
Manual References
TM 9-2320-387-24P
Equipment Condition
Vehicle raised and supported (para. 8-2).
NOTE
Perform steps 1 through 4 for vehicles equipped with 10,500 lb
hydraulic winch only.
1.
Remove two locknuts (3), washers (4), capscrews (18), washers (4), spacer (21), and left front brake
protection guard (19) from bracket (20) and bumper (22). Discard locknuts (3).
2.
Remove four locknuts (8), washers (9), capscrews (16), washers (9), two spacers (21), and right front
brake protection guards (10) from bracket (7) and bumper (13). Discard locknuts (8).
3.
Remove locknut (1), washer (2), capscrew (6), washer (2), and bracket (20) from front rear
crossmember (5). Discard locknut (1)
4.
Remove two locknuts (11), washers (12), capscrews (15), washers (12), and bracket (7) from front
crossmember (5). Discard locknuts (11).
5.
Remove two locknuts (3), washers (4), capscrews (18), washers (4), and left front brake protection
guard (19) from brackets (17) and (20). Discard locknuts (3).
6.
Remove four locknuts (8), washers (9), capscrews (16), washers (9), and right front brake protection
guards (10) from brackets (7) and (14). Discard locknuts (8).
7.
Remove two locknuts (1), washers (2), capscrews (6), washers (2), and brackets (17) and (20) from
front rear crossmember (5) and front crossmember (13). Discard locknuts (1).
8.
Remove four locknuts (11), washers (12), capscrews (15), washers (12), and brackets (7) and (14)
from front rear crossmember (5) and front crossmember (13). Discard locknuts (11).
a. Removal
Back to Top
