TB-9-2300-378-14
M48 & M60 SERIES VEHICLES
TECHNICAL BULLETIN; AIR INDUCTION SYSTEM MAINTENANCE
SEPTEMBER 1985
TB-9-2300-378-14 - Page 150 of 296
TB 9-2300-378-14
(7)
Remove four screws and lockwashers securing air intake cover to air intake.
Remove cover and gasket. Discard gasket (view C). Clean off old adhesive and
gasket material.
(8)
Remove six nuts and lock-washers (located inside air intake) securing gasket and
air intake flange to air intake. Remove gasket and flange.
Discard gasket and
lockwashers (view C). Clean off old adhesive and gasket material.
(9)
Clean screen if required.
b.
Installation.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Using adhesive (item 1, appendix C) cement new gasket on air intake flange (view
C). Secure flange to air intake with six nuts and new lockwashers.
Using adhesive (item 1, appendix C) cement new gasket on air intake cover.
Secure cover to intake with four screws and new lockwashers.
Using adhesive (item 1, appendix C) cement new gasket to bulkhead opening
inside crew compartment.
Put small amount of silicone compound (item 5, appendix C) on inside of hose
opening (view B). Put hose on
clamp.
Position air intake flange over
bulkhead with eight nuts and new
Put air intake hose on air intake
clamp.
Close top deck grille doors.
air intake flange.
Secure hose to flange with
bulkhead opening (view B). Secure intake to
lockwashers.
hose elbow (view A). Secure hose to elbow with
6-11. Air Cleaner Outlet Hose Assembly Replacement (Fig. 6-7).
NOTE
Replacement of left and right air cleaner outlet hose
assemblies is the same. Left side shown.
a.
Removal.
(1)
Open top deck door assemblies.
CAUTION
Do not open top deck doors when air cleaner door
is open. Damage to air cleaner door may result.
assembly
(2)
Pull pin and release quick release clamp.
Remove clamp from hose (views D and
E).
(3)
Remove screw clamp.
(4)
Remove hose.
(5)
Cover air cleaner outlet elbow and turbo-supercharger inlet elbow to prevent
entrance of foreign matter.
(6)
Remove performed packings (view D). Get rid of packings. Clean old adhesive
from packing groove on hose assembly.
(7)
Inspect hose assembly for damage or defective parts. Replace hose assembly if
hose or flange is unserviceable.
6-28
Back to Top
