TM-10-5411-233-13-P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER
TECHNICAL MANUAL; OPERATOR’S, UNIT, AND DIRECT SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
SEPTEMBER 2002
TM-10-5411-233-13-P - Page 47 of 356
TM 10-5411-233-13&P
CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER
0005 00
OPERATION UNDER USUAL CONDITIONS
0005 00-5
Positioning the Lifting/Locking Assemblies
WARNING
Be sure to support the lifting/locking assembly with a free hand before
removing the clevis pin that secures the assembly to the roof mounted
stowage block. Removing the clevis pin without supporting the
lifting/locking assembly will permit the assembly to swing down freely
causing a possible injury.
Remove the hairpin cotter
(1)
that secures the lifting/locking assembly bracket
(2)
to the stowage block
(3)
installed on the roof
(4)
of the upper section. While supporting the lifting/locking assembly
(5)
with a free
hand, pull the clevis pin
(6)
out and allow the lifting/locking assembly
(5)
to swing down and come to rest.
When the lifting/locking assembly
(5)
is almost vertical, rotate the entire assembly 180
0
for positioning
over the lower section corner fitting pulley assembly
(9)
.
Replace the clevis pin
(6)
in the stowage block
(3)
and reinstall the hairpin cotter
(1)
.
After allowing the lifting/locking assembly
(5)
to swing down and to rotate 180
0
from its stowed position,
remove the second hairpin cotter
(7)
that secures the handle
(8)
to the main body tube of the
lifting/locking assembly
(5)
. Swing the handle
(8)
down until it forms a 90
0
angle with the main body of the
lifting/locking assembly. Replace the hairpin cotter
(7)
in the clevis pin that secures the handle
(8)
.
4
5
5
3
1
7
90
0
8
6
2
9
Back to Top
