TM-5-2330-378-14-P
SEMITRAILER, LOWBED: 40 TON CONSTRUCTION EQUIPMENT TRANSPORTER M870 AND M870A1
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1999
TM-5-2330-378-14-P - Page 349 of 524
TM6-2330-378-1"P
E-3.
EXPLANATIONOFCOLUMNS(SECTIONS
IIANDIII)(continued).
d.
CAGEC[Column(4)].
Thecommercialandgovernmententitycode(CAGEC)
isafive-digitalphanumeric
code
used to identify the manufacturer,
distributor, or Government
agency, etc., that supplies the item.
NOTE
When you use an NSN to requisition an item, the item you receive may have a part
number different
from the part ordered.
e.
PART
NUMBER
[COLUMN
(5)].
Ind icates the primary
number
used by the manufacturer(individual,
company,
firm, corporation,
or Government
activity), which controls the design and characteristics
of the item by means
of its engineering
drawings, specifications
standards, and inspection requirements,
to identify an item or range
of items.
f.
DESCRIPTION
AND
USABLE-ON
CODE
(UOC)
[Column
(6)].
This
column
includes
the following
information:
(1)
The Federal item name and, when required, a minimum description to identifythe
item.
(2)
Physical security classification.
Not applicable.
(3)
Items that are included in kits and sets are listed below the name of the kit or set on Figure KIT.
(4)
Spare/repair
parts that make up an assembled
item are listed immediately following the assembled
item
line entry.
(5)
Part numbers for bulk materials are referenced
in this column in the line item entry for the item to be
manufactured/fabricated.
(6)
Whentheitem
is notusedwith
all serial numbers of the same model, the effective serial numbersareshown
on the last line(s) of the description (before the IJOC).
(7)
The IJOC, when applicable (see para E-5, Special Information).
(8)
In the Special Tools List section, the Basis of Issue (BOI) appears as the last line(s) in the entryforeach
special tool, special TIVIDE, and other special support equipment.
When density of equipments
supported
exceeds density spread indicated in the 801, the total authorization
is increased proportionately.
(9)
The statement "END OF FIGURE"appearsjustbelowthe
lastitern description inColumn 5foragivenfigure
in both Section
11and Section Ill.
g.
QTY [Column
(7)]. The QTY(quantity
perfigure) column indicates the quantity of theitern used inthebreakout
shown on the illustration/figure,
which is prepared for a functional group, subfunctional
group, oran assembly.
AV"
appearing
in this column in lieu of a quantity indicates that the quantity is variable and may vary from
application
to application.
E-6
Back to Top
