TM-5-2350-378-23-P
ARMORED COMBAT EARTHMOVER (ACE), M9; HYDRAULIC DIAGNOSTIC CENTER
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2012
TM-5-2350-378-23-P - Page 428 of 644
REMOVAL
NOTE
•
All transducers are removed and replaced in the same manner. This task covers the
removal and replacement of only one transducer.
•
Refer to Table 1. Hydraulic Diagnostic Center (HDC) Pressure Transducer Locations for
the location of each pressure transducer.
•
Tag electrical connector and hydraulic hose/tube to assist in installation. Plug fitting that
transducer is removed from to prevent leakage.
Table
1.
Hydraulic Diagnostic Center (HDC) Pressure Transducer Locations.
Transducer
Location
WP #
T3, T4, T12
Main hydraulic filter area
WP
0031
T5, T8
Right actuator access area
WP
0032
T6, T9
Left actuator access area
WP
0032
T7
Left main manifold
WP
0047
T1, T2, T13
Primary manifold
WP
0035
T10
Left forward manifold
WP
0036
T11
Main hydraulic filter area
WP
0037
1.
If wiring harness and connector are connected, disconnect transducer connector (Figure 1, Item 2) from wiring
harness connector (Figure 1, Item 1).
2.
Remove transducer (Figure 1, Item 4) and O-ring (Figure 1, Item 3) from component. Discard O-ring.
END OF TASK
INSTALLATION
1.
Install new O-ring (Figure 1, Item 3) and transducer (Figure 1, Items 2 and 4) on component.
2.
Connect transducer connector (Figure 1, Item 2) to wiring harness connector (Figure 1, Item 1).
TM 5-2350-378-23&P
0033
0033-2
Back to Top
