TM-5-2350-378-23-P
ARMORED COMBAT EARTHMOVER (ACE), M9; HYDRAULIC DIAGNOSTIC CENTER
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2012
TM-5-2350-378-23-P - Page 500 of 644
INSTALLATION OF ADJUSTABLE FITTINGS
1.
Apply engine lubricating oil to O-ring (preformed packing) (Figure 6).
CAUTION
Packing must be positioned fully into groove and not on threads. Failure to comply may result
in damage to equipment.
2.
Gently push backup washer and O-ring all the way into groove (Figure 6).
3.
Turn locknut down until locknut contacts backup washer (Figure 6).
4.
Install fitting on boss until backup washer contacts face of boss (Figure 6).
5.
Position fitting to desired position by backing out fitting up to one full turn. Hold fitting in desired position, and
tighten locknut (Figure 6).
6.
Connect tube to fitting after fitting is properly positioned and tightened (Figure 6).
LOCKNUT
BOSS
BACKUP WASHER
O-RING (PACKING)
LOCKNUT
GROOVE
BACKUP WASHER
PACKING GOES HERE
T0012HDC
Figure 6.
Adjustable Fittings.
END OF TASK
END OF WORK PACKAGE
TM 5-2350-378-23&P
0043
0043-6
Back to Top
