TM-5-2350-378-23-P

ARMORED COMBAT EARTHMOVER (ACE), M9; HYDRAULIC DIAGNOSTIC CENTER

TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JUNE 2012

  TM-5-2350-378-23-P - Page 602 of 644

INDEX - Continued
Subject
WP Sequence No.-Page No.
P
PART NUMBER INDEX.
.........................................................................................................
WP 0049-1
PRESSURE TRANSDUCERS REPLACEMENT.
...................................................................
WP 0033-1
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).
....................................
WP 0023-1
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) INTRODUCTION.
.......
WP 0022-1
R
REFERENCES.
.......................................................................................................................
WP 0050-1
REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL) INTRODUCTION.
.........................
WP 0044-1
S
SERVICE UPON RECEIPT.
....................................................................................................
WP 0024-1
STANDARD TWO-LEVEL MAC.
.............................................................................................
WP 0052-1
T
THEORY OF OPERATION.
....................................................................................................
WP 0003-1
TOOL IDENTIFICATION LIST.
................................................................................................
WP 0054-1
TROUBLESHOOTING INDEX.
...............................................................................................
WP 0005-1
TROUBLESHOOTING PROCEDURES - ALL HYDRAULIC FUNCTIONS
INOPERATIVE.
.......................................................................................................................
WP 0006-1
TROUBLESHOOTING PROCEDURES - APPARENT HYDRAULIC DIAGNOSTIC CENTER
(HDC) SYSTEM PROBLEM.
...................................................................................................
WP 0021-1
TROUBLESHOOTING PROCEDURES - APRON AND LEFT-HAND WHEEL CONTROL
INOPERATIVE.
.......................................................................................................................
WP 0007-1
TROUBLESHOOTING PROCEDURES - APRON WILL NOT RAISE.
...................................
WP 0008-1
TROUBLESHOOTING PROCEDURES - BUMP STOPS INOPERATIVE.
.............................
WP 0009-1
TROUBLESHOOTING PROCEDURES - EJECTOR CREEPS.
.............................................
WP 0010-1
TROUBLESHOOTING PROCEDURES - EJECTOR DOES NOT EXTEND OR
RETRACT.
...............................................................................................................................
WP 0011-1
TROUBLESHOOTING PROCEDURES - FRONT CORNER (LEFT OR RIGHT) DOES NOT
RAISE IN SPRUNG OR UNSPRUNG MODE.
........................................................................
WP 0014-1
TROUBLESHOOTING PROCEDURES - FRONT CORNER (LEFT OR RIGHT) RAISES IN
SPRUNG, BUT NOT UNSPRUNG MODE.
.............................................................................
WP 0012-1
TROUBLESHOOTING PROCEDURES - FRONT CORNER (LEFT OR RIGHT) RAISES IN
UNSPRUNG, BUT NOT SPRUNG MODE.
.............................................................................
WP 0013-1
TROUBLESHOOTING PROCEDURES - HYDRAULIC OIL OVERHEATS.
...........................
WP 0015-1
TROUBLESHOOTING PROCEDURES - LEFT REAR CORNER DOES NOT RAISE IN
SPRUNG OR UNSPRUNG MODE.
........................................................................................
WP 0016-1
TROUBLESHOOTING PROCEDURES - REAR OF VEHICLE RAISES IN SPRUNG, BUT
NOT UNSPRUNG MODE.
.......................................................................................................
WP 0017-1
TROUBLESHOOTING PROCEDURES - VEHICLE DOES NOT RESPOND TO OPERATOR
CONTROLS.
............................................................................................................................
WP 0018-1
TROUBLESHOOTING PROCEDURES - WINCH AND RIGHT-HAND WHEEL CONTROL
INOPERATIVE.
.......................................................................................................................
WP 0019-1
TROUBLESHOOTING PROCEDURES - WINCH WILL NOT PULL RATED LOAD.
..............
WP 0020-1
W
WIRING HARNESS W1 REPLACEMENT.
.............................................................................
WP 0030-1
WIRING HARNESS W2 REPLACEMENT.
.............................................................................
WP 0031-1
TM 5-2350-378-23&P
Index-2


Back to Top