TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 429 of 738
TM 5-2815-241-34&P
IDLER PULLEY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
15.
Bearing spacer (9)
a.
Position on idler shaft (2).
b.
Using arbor press and mandrel, press
bearing through oil seal (7) until
bottomed against bearing inner race.
16. Water pump (10)
Idler shaft (2), nut
(11), flat washer
(12), and fan adjust-
ing screw (13)
a.
Position shaft in adjusting slot (14).
b.
Put on nut and flatwasher.
Do not tighten.
c.
Screw fan adjusting screw into idler
shaft.
Do not tighten.
NOTE
Adjustments will be made when installing belts.
TASK ENDS HERE
TA 242609
2-407
Back to Top
