TM-5-3805-254-14-P-1

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR'S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

AUGUST 1980

TM-5-3805-254-14-P-1 - Page 262 of 590

Door reinforcement plates are normally needed, so have these plates made-up beforehand, using the dour mounts as

patterns.

The reinforcement plates are normally 1/8 to 3/16 (3.1 to 4.1 mm) steel straps having mating holes drilled and

tapped for the cap screws used to fasten the mirror door mounts.

On the front and rear of each reinforcing plate drill and

tap 2-each smaller screw holes to fasten the reinforcing plate onto the door permanently thus allowing removal of the

mirror door mount without loss of the reinforcing plate.

194