TM-5-3805-254-14-P-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)
JUNE 1980
TM-5-3805-254-14-P-2 - Page 55 of 894
MOTOR TRUCK SERVICE MANUAL
AXLES-REAR
DIFFERENTIAL REMOVAL
The procedure for removing the differential is the same as
used
for
a
conventional
differential.
IMPORTANT
PRECAUTION
Before disassembling the differential case,
insert a bolt through the center of the NoSPIN unit (axle shaft
openings) with a flat washer on each end against the side
members (Fig.
10).
Thread a nut on the bolt against the flat washer finger tight.
This will prevent possible injury caused by the unit flying apart
due to the spring pressure within itself during disassembly of
the differential case.
Back to Top
