TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980
TM-5-3805-254-14-P-2

  TM-5-3805-254-14-P-2 - Page 867 of 894

TRUCK SERVICE MANUAL
WHEELS, RIMS, TIRES
to clean an injury if a power buffer equipped with a fine
wire brush is used. Care must be taken not to buff
through the innerliner.
Clean the awl needle and dip in
self-vulcanizing fluid and from the inside of the tire, force
the needle through the puncture until the point extends
beyond the tread (Fig, 15).
3. Remove the detachable handle from the needle.
Cut a 3.175 mm (1/8") strip of filler rubber and
place it into the hole of the needle with the end of
the rubber strip extending beyond the needle.
Pull needle through the tire with a pliers (Fig. 16).
Filler rubber will remain in puncture. Using an
awl, pack excess rubber flush with inside of tire.


Back to Top