TM-5-3805-254-34
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
MARCH 1993
TM-5-3805-254-34 - Page 705 of 727
TM 5-3805-254-34
APPENDIX D
TORQUE LIMITS
D-1.
SCOPE.
This appendix lists standard torque values, as shown in Table D-1, and provides general information for applying
torque.
Special torque values and tightening sequences are Indicated in the maintenance procedures for applicable
components.
D-2.
GENERAL.
a.
Always use the torque values listed in Table D-1 when the maintenance procedure does not give a specific
torque value.
b.
Unless otherwise Indicated, standard torque tolerance shall be t 10%.
c.
Torque values listed are based on clean, dry threads.
Reduce torque by 10% when engine oil is used as a
lubricant.
Reduce torque by 20% if new plated capscrews are used.
d.
Capscrews threaded Into aluminum may require reductions In torque of 30% or more of Grade 5 capscrews
torque.
Capscrew threaded Into aluminum must also attain two capscrew diameters of thread engagement.
D-1
Back to Top
