TM-5-3805-274-13-P
DUMP TRUCK BODY M917
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
AUGUST 2013
TM-5-3805-274-13-P - Page 185 of 364
INSTALLATION - CONTINUED
NOTE
All fittings except for type I fittings used on hydraulic pump are
type II fittings as shown in Figure 1.
2.
If elbow fitting (Figure 1, Item 7) is removed, install new O-ring (Figure 1, Item 5) and elbow fitting
(Figure 1, Item 7) and tighten nut (Figure 1, Item 6).
3.
Install hose connector (Figure 1, Item 9) on elbow fitting (Figure 1, Item 7) and tighten swivel nut
(Figure 1, Item 8).
4.
Start engine and engage PTO (TM 9-2320-273-10). Check system for oil leaks, raise dump body bed and
lower safety strut to stowed position, lower dump body bed (WP 0008). Shut down engine
(TM 9-2320-273-10).
END OF TASK
END OF WORK PACKAGE
Figure 1. Type I and Type II Hydraulic Lines, Fittings, and Hoses Removal and Installation.
9
TYPE II
TYPE I
8
6
5
4
10
1
1
2
3
7
Figure 2. Hydraulic Line and Hose Routing.
FILTER
ASSEMBLY
PILOT
RELIEF
VALVE
CONTROL
VALVE
HOIST
CYLINDER
HYDRAULIC
PUMP
HYDRAULIC
RESERVOIR
TM 5-3805-274-13&P
0040
0040-3/4 blank
Back to Top
