TM-9-1290-262-24-P
AIMING CIRCLE, M2A2, W/E
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT,AND GENERAL SUPPORT MAINTENANCE MANUAL
SEPTEMBER 1994
TM-9-1290-262-24-P - Page 26 of 192
ARMY TM 9-1290-262-24&P
MARINE CORPS TM 00476C-24&P
AIR FORCE TO 49A7-3-72/74
2-9. STORAGE SITE.
Select the best available site for administrative storage. Separate stored
equipment from equipment in use. Conspicuously mark the area “Administrative Storage.” Covered
space is preferred.
2-10. STORAGE PLAN.
Store equipment so as to provide maximum protection from the elements
and to provide access for inspection and maintenance. Anticipate removal or deployment problems
and take suitable precautions.
2-11. MAINTENANCE SERVICES AND INSPECTION.
Prior to storage, perform the next
scheduled preventive maintenance service (monthly, quarterly, or semiannually). Inspect and
approve equipment prior to storage. Do not place equipment in storage in NMC condition.
2-12. CORRECTIONS OF SHORTCOMINGS AND DEFICIENCIES.
Correct all shortcomings
and deficiencies prior to storage, or obtain a deferment from the approving authority for uncorrected
shortcomings.
2-13. GENERAL CLEANING, PAINTING, AND PRESERVATION.
a.
Clean the equipment of dirt, grease, and other contaminants IAW this manual.
NOTE
Air circulation under draped covers reduces deterioration from moisture and heat.
b.
Sunlight, heat, moisture (humidity), and dirt accelerate deterioration. Install all covers
authorized for the equipment. Close and secure all openings except those required for venting and
draining. Seal openings to prevent entry of rain, snow, or dust. Place equipment and provide
blocking or framing to allow for ventilation and
that may rust, rot, or mildew.
c.
For further information and instructions
43-0139.
water drainage. Support cover away from surfaces
regarding corrosion prevention and control, refer to TM
2-14. PREPARATION OF FIRE CONTROL INSTRUMENTS.
Thoroughly clean and dry fire control instruments and coat unpainted surfaces with grease
(item 6, appx D).
b.
Wrap all optical glass with lens paper (item 7, appx D) and fasten with tape.
c.
Store all instruments on racks or in cases or protect with covers.
2-15. CARE OF EQUIPMENT IN ADMINISTRATIVE STORAGE.
a.
Maintenance Services. After equipment has been placed in administrative storage, suspend
all regularly scheduled preventive maintenance services and inspect and exercise as specified herein.
b.
Inspection. Inspection will usually be visual and must consist of at least a walk-around
examination of all equipment to observe any deficiencies that may have occurred. Inspect equipment
in open storage weekly and that in covered storage monthly.
2-10
Back to Top
