TM-9-2320-209-20-2-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 2 OF 3; PART 2 OF 2

MAY 1981

TM-9-2320-209-20-2-2 - Page 449 of 745

TM 9-2320-209-20-2-2

●

Put back cable that has come off of

discharge valve

●

●

●

●

●

Make sure valve and control levers

are in OFF positions. Refer to

TM 9-2320-209-10

Using 1/2-inch wrench loosen two

nuts on U-bolt

Slide cable end through U-bolt

and using pliers hold end tightly

Tighten two nuts on U-bolt using

1/2-inch wrench

Adjust cables. Refer to Vol 3,

chapter 18, para 18-25 or

18-27

•

Put back cable that has come off

control lever

●

●

●

●

●

Make sure valve and control lever

are in OFF positions. Refer to

TM 9-2320-209-10

Using 5/8-inch wrench loosen nut

Slide cable end through clamp

bolt and using pliers hold end

tightly

Tighten nut using 5/8-inch wrench

Adjust cables. Refer to Vol 3,

chapter 18, para 18-25 or 18-27

Ž

Replace broken discharge valve control

cable

●

Refer to Vol 3, chapter 18, para

18-25 or 18-27

Figure 65-5 (Sheet 2 of 3)

TA 114978

65-17