TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 303 of 830

TM 9-2320-209-20-3-1

1.

Put cable clamp (1) with cable (2) on bypass valve (3).

2.

Aline holes and put in capscrew (4) and screw on locknut (5).

3.

Put end of cable (2) 1/2 inch through hole in lever (6) and using screwdriver,

tighten screw (7). Using pliers, bend cable end at 45° angle.

4.

While holding lever (6) towards back of truck, slide cable case (2) in clamp (1)

until there is no slack between clamp and lever.

5.

Using 7/16-inch wrenches, tighten locknut (5) and cap screw (4).

GO TO FRAME 7

TA 08071 7

5-35