TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

  TM-9-2320-209-20-3-1 - Page 380 of 830

TM 9-2320-209-20-3-1
6-5. HOSES AND CLAMPS REMOVAL
TOOLS :
Flat-tip screwdriver
9/16-inch wrench (2)
SUPPLIES : Gasket
PERSONNEL: One
AND REPLACEMENT.
1/2-inch socket wrench
10-inch extension
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a.
Cooling System Hoses and Clamps.
(1) Preliminary procedures.
(a) Drain cooling system. Refer to para 6-10.
(b) Take off generator belts. Refer to para 6-9.
(2) Removal.
1.
Using screwdriver, loosen two screws (1).
2.
Slide two clamps (2) down on hose (3).
3.
Using 9/16-inch wrenches,
unscrew and take off locknut (4).
4.
Pull bolt (5) out of rod end clevis (6).
5.
Pull radiator (7) forward at top, just enough to take off hose (3).
6.
Pull hose (3) off.
Take clamps (2) off hose.
GO TO FRAME 2
TA 101584
6-20


Back to Top