TM-9-2320-209-34-1
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 1 OF 2
MAY 1981
TM-9-2320-209-34-1 - Page 11 of 129
TM 9-2320-209-34-1
CHAPTER 2
TROUBLESHOOTING APPROACH
2-1. GENERAL APPROACH.
This chapter gives you instructions on how to use the
troubleshooting material to help you find and fix the trouble. In every system of
the truck there can be faults or problems which will cause certain symptoms. Symp-
toms can be such things as unusual noise, vibration, or even complete failure of a
system. This volume gives information for each system on which you can do trouble-
shooting to find faults and fix them. Before you troubleshoot a system, you should
look at the troubleshooting indexes which will lead you to the information you need to
help make your troubleshooting faster and easier. If you follow the instructions the
right way, you will find those troubles you can fix. But, if you fix something and the
trouble is still there, it means there is more than one trouble. If this happens, start
all over again to find the other trouble.
2-2.
TROUBLESHOOTING INDEX.
The troubleshooting index, and instructions
how to use it are in chapter 3. Go to this index first because it tells you where
find troubleshooting roadmaps, fault symptom indexes, summary troubleshooting
charts and support diagrams for each system.
t o
2-3. TEST EQUIPMENT PROCEDURES INDEX.
The test equipment procedures index,
and instructions on how to use it are in chapter 4. This index tells you where to find
electrical and mechanical tests which you can use to do your troubleshooting. It also
tells you what equipment you will need to do the tests. If
YOU
have a STE/ICE
(Simplified Test Equipment/Internal Combustion Engine) Set (NSN 4910-00-124-2554),
you may use it, where applicable, to do your troubleshooting. Refer to
TM 9-4910-571-12&P.
2-4. TROUBLESHOOTING ROADMAPS.
Troubleshooting roadmaps for each system
are in chapter 5. If the system is made up of subsystems, these subsystems are also
on the roadmap.
Under the subsystem is a list of things which are the most likely
causes of a fault symptom in that subsystem. If you have enough skill, you can
troubleshoot these things on the truck without using the detailed troubleshooting
procedures.
So if you know enough about the truck to work on your own, use the
roadmap for the system with the problem before you check the fault symptom index.
2-5. FAULT SYMPTOM INDEX.
Fault symptom indexes and instructions on how to
use them are in chapter 6. For each system of the truck, there is an index which
gives you a list of the fault symptoms for that system. The index also tells you
where to find the detailed troubleshooting procedures and what resources (tools/
people) you need to do each procedure.
2-6. SAMPLE TROUBLESHOOTING PROCEDURE.
A sample troubleshooting procedure
is in chapter 7.
This sample procedure will help you see the way detailed trouble-
shooting procedures are to be used.
2-1/(2-2 blank)
Back to Top
