TM-9-2320-260-34-1
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 1 OF 2
JULY 1994
TM-9-2320-260-34-1 - Page 12 of 657
TM 9-2320-260-34-1
DETAILED MAINTENANCE PROCEDURES:
11.
12.
13.
14.
Detailed procedures: Include everything you must do to accomplish a basic maintenance task.
a.
b.
c.
d.
Before beginning the maintenance task, look through the procedure. You must familiarize yourself
with the entire maintenance procedure before beginning the maintenance task. The entire procedure
of paragraph 5-13: “Fuel Pump Replacement” includes: a. Removal and b. Installation.
The eight basic headings listed under “INITIAL SETUP” outline special tools, materials, personnel
requirements, and special conditions. Headings will not be listed if there are no entries. The
headings are:
APPLICABLE
MODELS
Any model(s) that require that particular maintenance task.
TEST EQUIPMENT
Test equipment needed to complete the task.
SPECIAL TOOLS
Special tools needed to complete the task.
TOOLS
Common tools, not in the General Mechanic’s Tool Kit, needed to complete the task.
MATERIAIS/PARTS
All parts or materials needed to complete the task.
PERSONNEL REQUIRED
The number of personnel needed to perform the task. If only one
mechanic is needed, this heading will not be used. If you think that you need more help to
correctly or safely complete a task (perhaps as the result of unusual conditions, etc.), alert
your supervisor and ask for help.
REFERENCES (TM)
Additional manuals needed to complete the task.
EQUIPMENT CONDITION
Notes the conditions that must exist before starting the task.
GENERAL SAFETY INSTRUCTIONS
Summarizes all safety warnings for the maintenance task.
A step-by-step maintenance procedure follows the “INITIAL SETUP" and gives detailed instruc-
tions for the procedure. These instructions give part name and action performed. The numbers in
parentheses correspond to the part’s callout number in the accompanying illustration. Warnings,
cautions, and notes give additional information.
WARNINGS
-
Indicate conditions, practices, or procedures which must be observed to avoid
personnel injury, loss of life, or long-term health hazard.
CAUTIONS
- Indicate conditions, practices, Or procedures which must be observed to avoid
damage to equipment or destruction of equipment.
NOTES
–
Include essential information of special importance, interest, or aid in job
performance.
At the end of a procedure, “FOLLOW-ON TASK(S)” will list the additional task(s) that must be
performed to complete the procedure.
You can also use the Table of Contents (page ii) to find more information about the vehicle.
Refer to TM 9-2320-260-34P, Direct Support and General Support Maintenance Repair Parts and
Special Tools List for Truck, 5-Ton, 6x6, M809 series, when requisitioning parts, special tools, and
equipment for direct support and general support maintenance.
Your manual is easier to use once you understand its design. We hope it will encourage you to use it
more often as an aid to maintenance support for M809 series vehicles.
. . .
viii
Back to Top
