TM-9-2320-272-24-4
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL; VOLUME 4 OF 4
JUNE 1998
TM-9-2320-272-24-4 - Page 684 of 836
TM 9-2320-272-24-4
Section Ill. TOOL AND TEST EQUIPMENT REQUIREMENTS (Contd)
(1)
(2)
(3)
(4)
(5)
REFERENCE MAINTENANCE
NATIONAL/NATO
TOOL
CODE
CATEGORY
NOMENCLATURE
STOCK NUMBER
NUMBER
29
H
Tappet Holder
KDEP-1068
30
H
Spring Compressor
KDEP-1505
31
H
Plunger Lift Device
1-688-130-135
32
H
Rack Extension
9-681-233-100
33
H
Fuel Pump Test Stand
DFP 156
34
H
Cylinder Liner Clamps
3822503
35
H
Mechanical Puller
3822786
36
H
Cylinder Liner Puller
3376015
37
H
Torque Angle Gauge
3823878
38
H
Tester, Injector Nozzle
7551255
39
H
Puller Kit
J24420C
Section IV. REMARKS
REFERENCE
CODE
REMARKS
A
Perform PMCS as shown in TM 9-2320-272-10.
B
Engine overhaul will be in accordance with DMWR 9-2815-500.
C
Welding will be in accordance with TM 9-237.
D
Repair of lines and fittings will be in accordance with TM 9-243.
E
Test and repair of radiator will be in accordance with TM 750-254.
F
Repair of alternator will be in accordance with TM 9-2920-225-34.
G
Repair of starter will be in accordance with TM 9-2920-243-34.
H
Repair of batteries will be in accordance with TM 9-6140-200-14.
I
Transmission overhaul will be in accordance with DMWR 9-2520-522.
J
Transfer overhaul will be in accordance with DMWR 9-2520-530.
K
Overhaul of front and rear axle will be in accordance with DMWR 9-2520-508.
L
Tires/Tubes:
Repair and Inspection TM 9-2610-200-14
Storage
TM 743-200-1
M
Repair of frames will be in accordance with TB 2300-247-40.
N
Metal body repair will be in accordance with FM 43-2.
O
Overhaul of front and rear winches will be in accordance with DMWR 9-3830-501.
P
Refer to kit installation instructions for kit installation.
Q
Inspection of brake lines will be in accordance with TB 9-2300-405-14.
R
Service/inspection of winch/hoist wire rope/cables will be in accordance with
TB 43-0142 and TB 9-0352.
S
Repair of heaters will be in accordance with TM 9-2540-205-24&P.
T
Repair of canvas will be in accordance with FM 10-16.
U
Operation of fuel pump test stand, P/N DFP 156, will be in accordance with
TM 9-4910-778-14&P.
V
Engine overhaul will be in accordance with DMWR 9-2815-358.
B-26
Back to Top
