TM-9-2320-273-10
TRUCK, TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; OPERATOR’S MANUAL
DECEMBER 2012
TM-9-2320-273-10 - Page 167 of 452
OPERATOR MAINTENANCE
OPERATING UNDER USUAL CONDITIONS
PLACING VEHICLE IN MOTION
INITIAL SETUP:
References
WP 0005
WP 0007
WP 0008
WP 0009
WP 0012
References - Continued
WP 0013
WP 0018
WP 0027
WP 0037
PLACING VEHICLE IN MOTION
WARNING
To prevent fifth wheel movement during transit, ensure cab
mounted sliding fifth wheel control lever is in LOCK
position before moving vehicle. Follow procedure to verify
fifth wheel control lever is locked in position when tractor is
coupled to trailer, and never move fifth wheel control lever
to UNLOCK position during transit. Failure to comply may
result in loss of control, damage to equipment, and possible
injury or death to personnel. Seek medical attention in the
event of an injury.
Do not operate vehicle with low tire pressure on wet smooth
roads at high speeds. Doing so may result in loss of control,
damage to equipment, and possible injury or death to
personnel. Seek medical attention in the event of an injury.
Due to increased weight and raised center of gravity on
vehicles equipped with Crew Protection Kit, vehicle operator
must be aware of differences in driving characteristics and
adjust driving accordingly. Failure to comply may result in
damage to equipment or possible injury or death to
personnel. Seek medical attention in the event of an injury.
1. Ensure BII and auxiliary equipment are stowed and locked for travel (WP 0037).
2. If tractor is coupled to trailer, ensure fifth wheel primary and secondary kingpin
lock releases are properly engaged, tractor-to-trailer air and electrical connections
are checked, and the sliding fifth wheel control lever is in LOCK position for the
M915A1 (WP 0012). If using towing pintle, ensure pintle is properly locked
(WP 0013).
TM 9-2320-273-10
0010
0010-1
Back to Top
