TM-9-2320-280-20-1

TM 9-2320-280-20-1

On page 3-12 you find paragraph 3-8, the detailed procedure for replacing the oil cooler assembly.

d. DETAILED MAINTENANCE PROCEDURES.

Detailed maintenance procedures include everything

you must do to accomplish a basic maintenance task. Unless otherwise stated, general mechanic’s

automotive tool kit will be used for maintenance of this vehicle.

Before beginning the maintenance task, look through the procedure. You must familiarize yourself

with the entire maintenance procedure of para. 3-8: "Engine and Transmission Oil Cooler Assembly

Maintenance". The task includes "a. Removal" "b. Installation" and "c. Cleaning and Inspection".

The ten basic headings listed under “INITIAL SETUP” outline task conditions, materials, special

tools, manpower requirements, and special conditions. The headings are:

Applicable Models:

Any models that require a particular maintenance task. If a maintenance task

covers all models, then this heading will not be used.

Test Equipment:

Test equipment needed to complete a task. If test equipment is not required, this

heading will not be used.

Tools

These are common tools and general mechanic tool sets required to perform

maintenance tasks. These common tools should be on hand to properly perform the task. Torque

wrenches are required for many tasks; the proper torque wrench should be available to tighten

mounting hardware.

Special Tools:

Those special tools needed to complete a maintenance task. If no special tools are

needed, this heading will not be used.

If you don’t have one of these special tools, requisition it (before starting the task) using the data

supplied in TM 9-2320-280-24P, the repair parts and special tools list for this level of maintenance.

Special tools are located in section III.

Materials/Parts:

This heading lists only mandatory replacement materials or parts (gaskets, O-

rings, sealant, etc.). To replace other unserviceable parts, refer to TM 9-2320-280-24P for requisition

data. If no mandatory replacement materials/parts are required, this heading will not be used.

TM-9-2320-280-20-1 - Page 29 of 888