TM-9-2320-280-20-2
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3
JANUARY 1996
TM-9-2320-280-20-2 - Page 442 of 951
4-100. NBC CONTROL BOX AND WIRING HARNESS REPLACEMENT (M997, M997A1,
M997A2) (Cont’d)
8.
Remove two tiedown straps (6). Disconnect leads 784A (4) and 784B (12) from NBC heaters (1).
Discard tiedown straps (6).
9.
Remove four capscrews (3), washers (2), and mounting bracket (16) from body (14). Pull
bracket (16) and NBC heaters (1) away from body (14) to allow access to ground leads (5) hardware.
10.
Remove nut (13), capscrew (15), and ground terminals (5) from NBC heaters (1).
11.
Remove screw (9), lockwasher (10), clamp (11), and harness (7) from A/C control box (8) and
body (14). Remove clamp (11). Discard lockwasher (10).
12.
Route harness (7) through body (14) into cab.
13.
Remove two screws (26), clamps (25) and harness (7) from body (21).
14.
Disconnect harness lead 785A (35) from NBC heater lead (36).
15.
Remove nut (29), washer (30), capscrew (32), washer (30), and leads 796 and 796A (31) from NBC
heater (33).
16.
Remove five screws (27), clamps (28), harness (7), and intercom cable (24) from body (21). Remove
clamps (28).
17.
Remove tiedown straps (19) and (34). Disconnect harness lead 786A (40) from NBC heater
lead (41). Discard tiedown straps (19) and (34).
18.
Remove locknut (43), washer (17), capscrew (18), washer (17), and leads 796B and 796A (42) from
NBC heater (44). Discard locknut (43).
19.
Remove two assembled locknuts (20), capscrews (37), washers (38), clamp (39), grommet (22),
retainer (23), harness (7), and intercom cable (24) from body (21). Discard assembled locknuts (20).
TM 9-2320-280-20-2
4-204
Change 3
Back to Top
