TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 454 of 951

4-101. INTERIOR LIGHTING HARNESS ASSEMBLY REPLACEMENT (M997, M997A1,

M997A2) (Cont’d)

TM 9-2320-280-20-2

4-216

Change 3

22.

Remove four screws (7) from cover (6) and body (14).

23.

Remove nut (3), screw (10), and cover (6) from two clamps (11) and light harnesses (11.1).

24.

Disconnect four harness leads (5) from light leads (4).

25.

Remove ten screws (13) from cover (8) and body (14). Lower cover (8) to allow access to harness (1).

26.

Disconnect six harness leads (2) from light harness leads (12). Remove grommet (9) and harness

cover (8).

CAUTION

Use care when removing harness. Failure to do so will cause

damage to harness.

27.

Remove harness (1) from body (14).

CAUTION

Use care when routing harness. Failure to do so will cause

damage to harness.

1.

Route harness (1) through vehicle in approximate mounting location.

2.

Position harness cover (8) over harness (1) and connect six harness leads (2) to light harness

leads (12). Install grommet (9) and cover (8) to body (14) with ten screws (13).

3.

Connect four harness leads (5) to light leads (4).

4.

Install two clamps (11) and light harnesses (11.1) on cover (6) with screw (10) and nut (3).

5.

Install cover (6) on body (14) with four screws (7).

6.

Install six clamps (15) on harness (1) and body (17) with six screws (16).

b. Installation