TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 916 of 951

9-14. RECEPTACLE MOUNTING BRACKET REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Applicable Models

All vehicles except M996, M996A1, M997,

M997A1, M997A2, M1037, M1042

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Materials/Parts

Two locknuts (Appendix G, Item 79)

Four assembled locknuts (Appendix G, Item 130)

Manual References

TM 9-2320-280-24P

1.

Remove four assembled locknuts (9), capscrews (6), cover (5), and receptacle (1) from bracket (4).

Discard assembled locknuts (9).

NOTE

• If bracket is held on to “D” beam with rivets, proceed to step 2. If

not, proceed to step 3.

• For instructions on removal of rivets, refer to para. 10-66.

2.

Remove two rivets and bracket (4) from “D” beam (3).

3.

Remove two locknuts (2) capscrews (8), washers (7), and bracket (4) from “D” beam (3).

Discard locknuts (2).

NOTE

If bracket was held on to “D” beam with rivets, do step 1. If not,

do step 2.

1.

With a 0.3125-in. drill bit, enlarge existing rivet holes on bracket (4) and “D” beam (3).

2.

Install bracket (4) on “D” beam (3) with two washers (7), capscrews (8), and locknuts (2).

3.

Install receptacle (1) and cover (5) on bracket (4) with four capscrews (6) and assembled locknuts (9).

b. Installation

a. Removal

TM 9-2320-280-20-2

Change 3

9-21