TM-9-2320-280-20-3
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3
JANUARY 1996
TM-9-2320-280-20-3 - Page 93 of 1168
TM 9-2320-280-20-3
I
10-47. SEATBELT ASSEMBLY REPLACEMENT
I
This task covers:
a Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic’s tool kit
●
Passenger seat back removed, rear seatbelt only (para. 10-45).
automotive (Appendix B, Item 1)
●
Companion seat and battery box cover removed,
Manual References
companion seatbelt only (para- 10-35).
TM 9-2320-280-24P
General Safety Instructions
Seatbelts are to be replaced as a set.
WARNING
Seatbelts are to be replaced as a set. Failure to do this may cause
injury to personnel or damage to equipment.
NOTE
●
This procedure applies to all vehicles with serial numbers USBL
Eff. 99,999 and below.
●
All seatbelt removal and installation procedures are basically
the same. This procedure covers the driver’s seatbelt.
1. Remove anchor bolt (8), buckle assembly (7), and washer (6) from bracket (5).
2. Remove anchor bolt (4), connector assembly (3), and washer (2) from body (1).
I
b. Installation
1. Install washer (2) and connector assembly (3) on body (1) with anchor bolt (4). Tighten anchor bolt (4)
to 35-40 lb-ft (47-54 Nom).
2. Install washer (6) and buckle assembly (7) on bracket (5) with anchor bolt (8). Tighten anchor bolt (8)
to 35-40 lb-ft (47-54 Nom).
FOLLOW-ON TASKS: . Install passenger seat back, rear seatbelt only (Pam. 10-45).
●
Install companion seal battery box cover, companion seatbelt only (para. 10-35).
10-75
Back to Top
