TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 172 of 1258
TM 9-2320-280-34
3-23.
ENGINE INSTALLATION (6.2 L) (Cont ’d)
NOTE
Early production vehicles used studs to secure splash shields to
airlift brackets.
150.
Install left splash shield (10) on bracket (11) with washer (9), capscrew (12), washer (9), and
locknut (8).
151.
Install harness and clamp (22) on splash shield (10) with screw (21) and nut and lockwasher
assembly (23).
152.
Install connector receptacle (19) on bracket (17) with four screws (18).
Tighten receptacle cover (20).
153.
Install left splash shield (10) on airlift bracket (4) with lockwasher (15) and capscrew (14).
Tighten capscrew (14) to 15 lb-ft (20 Nm).
154.
Install left splash shield (10) on airlift bracket (4) with washer (6), capscrew (13), washer (7),
washer (6), and locknut (5).
Tighten capscrew (13) to 95-145 lb-in.
(11-16 Nm).
155.
Install left splash shield (10) on support bracket (1) with washer (2), capscrew (16), washer (2), and
locknut (3).
Tighten capscrew (16) to 6 lb-ft (8 Nm).
156.
Install right splash shield (38) on airlift bracket (4) with lockwasher (25) and screw (26).
157.
Install right splash shield (38) on airlift bracket (4) with washer (32), capscrew (34), washer (33),
washer (32), and locknut (31).
Tighten capscrew (34) to 15 lb-ft (20 Nm).
158.
Install right splash shield (38) on support bracket (29) with washer (28), capscrew (30), washer (28),
and locknut (27).
Tighten capscrew (30) to 15 lb-ft (20 Nm).
159.
Install fuel line clamp (37) on splash shield (38) with washer (36), capscrew (24), and locknut (35).
Tighten capscrew (24) to 15 lb-ft (20 Nm).
3-110
Back to Top
