TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 622 of 1258
TM 9-2320-280-34
14-6.
CARGO SHELL REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Applicable Models
Manual References
All except M996, M996A1, M997, M997A1,
TM 9-2320-280-20
M997A2, M998, M998A1, M1035, M1035A1,
TM 9-2320-280-24P
M1035A2, M1037, M1038, M1038A1, M1042,
M1097, M1097A1, M1097A2
Equipment Condition
Cargo shell door removed (TM 9-2320-280-20).
Tools
Front and rear strikers removed
General mechanic's tool kit:
(TM 9-2320-280-20).
automotive (Appendix G, Item 1)
Antenna removed (TM 9-2320-280-20), if present.
Materials/Parts
Dovetail spring removed (TM 9-2320-280-20).
M966, M966A1, M1036, M1045, M1045A1,
Nineteen locknuts (Appendix E, Items 57)
M1045A2, M1046, and M1046A1 only:
Two locknuts (Appendix E, Item 60)
M16 ammo rack removed, left cargo shell only
Seven rivets (Appendix E, Item 140)
(TM 9-2320-280-20).
Nut and lockwvasher assembly
M1043, M1043A1, M1043A2, M1044, and M1044A1
(Appendix E, Item 96)
only:
Grease (Appendix B, Item 21)
Ammo box tray removed (TM 9-2320-280-20).
Adhesive tape (Appendix B, Item 58)
Maintenance Level
Personnel Required
Direct support
One mechanic
One assistant
NOTE
•
The procedures for removing and installing the right cargo shell
and left cargo shell are basically the same.
This procedure covers
the right cargo shell.
•
For instructions on replacement of rivets, refer to para.
22-7.
a.
Removal
1.
Remove seven rivets (19) and panel (18) from cargo shell (8) and wheelhouse (11).
2.
Remove two locknuts (9), washers (10), and screws (13) from cargo shell (8) and striker mounting
plate (12).
Discard locknuts (9).
3.
Remove nine locknuts (14), washers (7), capscrews (6), washers (7), and spacers (17) from cargo shell (8)
and wheelhouse (11).
Discard locknuts (14).
4.
Remove two locknuts (15), washers (16), capscrews (20), and washers (16) from cargo shell support
tube (2) and wheelhouse (11).
Discard locknuts (15).
5.
Remove two locknuts (5), washers (4), capscrews (3), and washers (4) from cargo shell support tube (2)
and 'C, pillar (1).
Discard locknuts (5).
6.
Remove capscrew (28), washer (27), snubber (26), mount (25), bushing (24), and plate (22) from rear
ring support (23) and C" pillar support bracket (21).
14-22
Back to Top
