TM-9-2320-283-34-1
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-1 - Page 147 of 624
TM 9-2320-283-34-1
COOLING SYSTEM.
3-18.
FAN CLUTCH REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
E.
ASSEMBLY
(Continued).
NOTE
Steps 20 thru 22 should all be performed within fifteen minutes to prevent
Loctite® from setting up.
*For the next step, support shaft and bracket assembly (5) with shaft (10)
pointing up.
20. Pulley assembly
a. Apply a thin coat of Loc-
The bottom portion of
(1)
tite RC601® around the
item (10) is the mount-
bottom portion of item
ing location for item
(10).
(1).
b. Apply a thin coat Loctite
RC601® to inner race of
two items (3).
c. Slide onto item (10) as
far as it will go.
21. 0-ring (11),
Install on item (10) to
Use spanner wrench to
housing (12),
secure item (1).
torque item (14) to
lockwasher (13),
100-150 lb-ft.
.
and nut (14).
CAUTION
Care must be taken to ensure that finish of piston housing (12) is not
damaged.
Damage to finish could cause air leaks.
22. Lockwasher (13).
Bend up one of its tabs into
one of the spanner grooves of
item (14).
NOTE
Allow Loctite RC601 ®
to dry for approximately twenty-four hours before
you continue with the steps below.
3-94
Back to Top
