TM-9-2320-283-34-1
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-1 - Page 90 of 624
TM 9-2320-283-34-1
ENGINE.
3-10. ENGINE REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
C. INSTALLATION (Continued).
56. Two washers (117)
Position items (108) and
and washers (108).
(117) on top of two items
(109) and two items (116).
57. Engine hoist.
Move engine into engine
Use two MOS-63W person-
compartment and lower onto
nel to guide engine.
item (115) and two items (110).
Watch clearance between items
(25) and (137) and vehicle frame.
58. Two capscrews (106).
Install items (106) through
Long drift pin may be
two items (107), (108),
needed to line up
(109), and (110).
mounting holes.
59. Two washers (111)
Install two items (111) and
Tighten two items (112)
and nuts (112).
(112) on two items (106).
finger tight.
60. Two capscrews
Install items (113) and (114)
Long drift pin may be
(113) and washers (114).
through two items (115),
needed to line up
(116), and (117).
mounting holes.
61. Two nuts (118).
Install two items (118) on
Tighten two items (118)
two items (113).
finger tight.
62. Nut (125) and washer (126).
a. Position item (124) on item (123).
Reach through floorboard access
hole.
b. Secure with item (125) and (126).
63. Two capscrews (3)
Using suitable drift, aline
Reach through floor-
and transmission (4).
mounting holes in items (4)
board access hole. Use
and flywheel housing.
transmission jack and/or
Install two items (3).
hoist to aline position of mounting
holes.
3-36
Back to Top
