TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 12 of 570
TM 9-2320-283-34-2
FRONT AXLE.
3-60. FRONT AXLE REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
A. REMOVAL
NOTE
Before removing front axle, make sure
front of vehicle is supported by two
jack stands as shown in illustration.
1. Front nondriving
Position floor jack under
axle assembly (1).
center and raise until weight
of item (1) is supported.
2. Eight nuts (8),
washers (7), and
Remove from four items (3)
and item (1).
two brackets (6).
3. Front nondriving
axle assembly (1).
a. Using floor jack, lower
and remove from under
vehicle.
b. Using suitable lifting
device, lift off of floor
jack and place on clean
work surface.
B. CLEANING
4. All parts.
Clean.
C. INSPECTION.
5. All parts.
Inspect.
Use floor jack rated for
ten ton capacity.
It is not necessary to
remove four items (3)
from two items (5).
Have assistant help guide
item (1) during removal.
Refer to paragraph 3-4.
Refer to paragraph 3-5.
If either items (20) or
items (4) are damaged,
refer to TM 9-2320-283-20
for repair. If item (1)
is damaged, replace it
with items (5) and (2)
attached.
3-568
Back to Top
